Has any one had problems with their battery and tank monitor system? Mine worked two weeks ago after making my last trip. Now it does not. I have the master switch on, my voltage is 13.1volts and the water pump which shares the same power works. I checked the switch function with a volt meter and it seems fine. I crawled under the trailer and all wiring seems OK. I am at a loss as to what to check now. Any one have a suggestion?
I figured out the issue Jim by going to the troubleshooting guide of KIB Industries. I have lost my ground and proved that with a jumper connected to the furnace frame. Now I just have to figure out or learn from Reace where they landed the white grounding wire. It goes into the wall.
Contact Reace. There's a test you can do to determine what the fault is. Ours went haywire in our 2011 19 and it was something on the board. The tank levels kept showing wonky readings. Too difficult to replace the part so they replaced the whole board. Works fine now.
Linear Mode
