We just picked up our trailer last week and our spring field Dycor table is leaning. I would like to see someone else's and talk with them. If anyone knows who has one here.
We have a 21' with no u-dinette, and we had ETI put in the Springfield air pedistal, with the stock ETI slider
when it is down, it fits perfectly into the side supports - flat.
however when it is up, the table top is sloped noticeably, towards the back IIRC.
Have not gotten around to addressing this.
anyone else have this as well?
Posting this here as it relates to the original post.
john
Yes we had that issue when first installed Springflied . I think the table is a little big for pedestal . Besides making better access for getting into drivers side and the slopping of table , cut table too down only on one side about 12 in total , 8 in and 4 in . Table still will sit on ledge for bed because only cut one side . Table is now 29 1/2 by 30 in. Table now rotates all the way around if needed. Table doesn't slope anymore . I had talked to Overton's when first ordered and they had to have less gas pressure in pedestal because it was too hard to push down before . So probably because the regular dinette table is quite big table , you get that slope . Use cut off piece for extension at kitchen sink . Also replaced the trim to black when I cut table . Or you can make a new table smaller . Pat
We just picked up our trailer last week and our spring field Dycor table is leaning. I would like to see someone else's and talk with them. If anyone knows who has one here.
Go see JB & his spiffed-up 5.0. May cost you some $$ for tix