Where the post attaches to the floor - We have the original table with 2 legs. What would that look like, to replace that with what you have? How have others covered up the holes left from the 2-legged table, and with what kind of success? Thanks all.
Mine left some holes in the floor exposed, I think they were #12 screws so they are pretty big. I used a vinyl floor repair kit, worked fine. I know where the holes are and can see the fix if I look, no one else would ever notice. Similar to this one,
Yes, the holes are very visible. I used a light colored epoxy wood filler to fill them. I have the factory flooring which is light colored. They are almost invisible now; you would not notice them unless you knew. I don't have a picture, but will get one the next time I'm at my camper.
What pedestal did you use? Been thinking about it but have not seen it done.
I assume the table is permanently mounted and can't be easily removed. I am
thinking about getting to the electronics below the table. It could be a pain
getting to them with the table there
Linear Mode
