Do you recall if you had to take the sensor batteries out? I'm concerned about the alarm going off because the sensor could be reading zero pressure? Thanks.
Quote:
Originally Posted by Effie
I was running my four wheel version on two wheels only for awhile, worked fine, the unused channels just don't show any reading.
No this is not necessary, if a sensor is not transmitting the receiver have no information about this channel, the display for this sensor is going to be blank. I noticed when powering up the receiver after the trailer did not move for a while, the display is blank until the sensors wake up and start transmitting.
I also noticed that the sensors start transmitting as they get attached to the wheels, probably because of the sudden pressure.