|
04-11-2016, 02:20 PM
|
#1
|
Senior Member
Join Date: May 2015
Location: Seatac, Washington
Trailer: "The Trailer", 2nd Gen 21' & a 2017 Tundra CrewMax in Blazing Blue Pearl
Posts: 2,888
|
High Lift Axle vs Steep Driveway
Okay, I've read about the high lift axle and kind of forgot/ignored many of the posts. I know it's available on the 21 (for an extra 300 bucks). I know it can be used if you're worried about clearance in certain road conditions.
But, what I don't remember is if it'll help you get your trailer up and down a steeper driveway. Instead of parking the trailer in the flat gravel area, yesterday we were talking about backing it down the driveway. That way another vehicle will be in front of it most of the time and it'll be that much harder to "borrow".
I could not tell you the angle of the driveway. It's compacted gravel and it's steep enough that if you have to stop for passing traffic, you spin gravel all over the place unless you back farther down and start over again.
yeah, not technical, but it's the best I can do. We're still looking at our options, so I thought I'd toss that out into the mix. Dirk doesn't think the few inches higher axle will make a difference. I'm wondering what others that have it have to say about it. Or know far more about it than we do.
Thanks much gang!
|
|
|
04-11-2016, 03:55 PM
|
#2
|
Senior Member
Join Date: Dec 2012
Location: Edmonton, Alberta
Trailer: 1979 Boler B1700
Posts: 14,935
|
Yes, the "lift" raises the whole trailer (other than the axle/suspension itself), so it raises both the bumper and the tongue & hitch (which might drag when the trailer wheels are in the dip a the bottom of the driveway).
|
|
|
04-11-2016, 04:42 PM
|
#3
|
Senior Member
Join Date: Mar 2014
Location: petaluma, California
Trailer: 2015 Escape 21 2002 Tundra 4x4 V-8 tow package.
Posts: 163
|
If I read this correct, you are transitioning from flat/level to downhill . If that's the case not too sure a lift kit will help . If the transition is from level/flat to uphill……High lift axel will help. Or place blocks/boards at the low point of the transition ( gutter)
If you are spinning your wheels on your car as you exit due to the steepness…. You might need four wheel drive to pull the trailer out ?
|
|
|
04-11-2016, 04:55 PM
|
#4
|
Senior Member
Join Date: May 2015
Location: Seatac, Washington
Trailer: "The Trailer", 2nd Gen 21' & a 2017 Tundra CrewMax in Blazing Blue Pearl
Posts: 2,888
|
Quote:
Originally Posted by craiginpetaluma
If I read this correct, you are transitioning from flat/level to downhill . If that's the case not too sure a lift kit will help . If the transition is from level/flat to uphill……High lift axel will help. Or place blocks/boards at the low point of the transition ( gutter)
If you are spinning your wheels on your car as you exit due to the steepness…. You might need four wheel drive to pull the trailer out ?
|
Yep, we'd back the trailer down the driveway and pull it straight out. Yeah, we have to use 4x4 some times to get out of the driveway but it's way better than it used to be (crappy surface of dirt, some gravel and ratty blacktop stuff that was laid down years ago). And yeah, we'd probably use it to pull it out.
We're gonna get a new Tundra to pull it with. At this rate and if the trailer isn't coming earlier than hoped for, it'll probably be a 2017 model!
|
|
|
04-11-2016, 04:55 PM
|
#5
|
Senior Member
Join Date: Dec 2012
Location: Edmonton, Alberta
Trailer: 1979 Boler B1700
Posts: 14,935
|
Quote:
Originally Posted by craiginpetaluma
If I read this correct, you are transitioning from flat/level to downhill . If that's the case not too sure a lift kit will help .
|
Oops, I missed that. It does look like the driveway slopes down from the road (rather than the more common up from the road), and I agree that in that case a lift kit won't help much. If the trailer frame between coupler and axle drags on the edge of the road, a trailer lift will help a little, but this isn't usually a big problem.
|
|
|
04-11-2016, 04:56 PM
|
#6
|
Senior Member
Join Date: Oct 2008
Location: Calgary, Alberta
Trailer: 2017 Escape 5.0 TA
Posts: 15,543
|
Quote:
Originally Posted by craiginpetaluma
If I read this correct, you are transitioning from flat/level to downhill . If that's the case not too sure a lift kit will help . If the transition is from level/flat to uphill……High lift axel will help. Or place blocks/boards at the low point of the transition ( gutter)
If you are spinning your wheels on your car as you exit due to the steepness…. You might need four wheel drive to pull the trailer out ?
|
I was pretty much thinking along the same line on both accounts. That reversing into a drop does not require a raised axle, and getting out could be tough, given a car spins out.
I had the high lift on my 19, and really did not need it, even when travelling rough roads.
__________________
2017 Escape 5.0 TA
2015 Ford F150 Lariat 3.5L EcoBoost
2009 Escape 19 (previous)
“Most folks are about as happy as they make up their minds to be.” — Abraham Lincoln
|
|
|
04-11-2016, 04:58 PM
|
#7
|
Senior Member
Join Date: May 2015
Location: Seatac, Washington
Trailer: "The Trailer", 2nd Gen 21' & a 2017 Tundra CrewMax in Blazing Blue Pearl
Posts: 2,888
|
Quote:
Originally Posted by Brian B-P
Oops, I missed that. It does look like the driveway slopes down from the road (rather than the more common up from the road), and I agree that in that case a lift kit won't help much. If the trailer frame between coupler and axle drags on the edge of the road, a trailer lift will help a little, but this isn't usually a big problem.
|
Yep, it drops down below the road level. We might still park it on the upper, level gravel area, but we're exploring options right now.
There's only so much I can purchase for it. So, gotta do something while I'm impatiently waiting for it to get into the production queue.
Thanks for your replies, guys.
|
|
|
04-12-2016, 04:01 PM
|
#8
|
Member
Join Date: Aug 2015
Location: Northern, Wisconsin
Trailer: 2020 21C
Posts: 90
|
The high lift axle was one of my questionable options also, Reece said it could be added later.
Something to check into.
|
|
|
04-12-2016, 04:37 PM
|
#9
|
Senior Member
Join Date: Nov 2015
Location: Baytown, Texas
Trailer: 2017 21' Escape - upgraded version
Posts: 2,697
|
Does anyone know the hitch ball height difference between the standard and the high lift?
|
|
|
04-12-2016, 05:29 PM
|
#10
|
Senior Member
Join Date: Dec 2012
Location: Edmonton, Alberta
Trailer: 1979 Boler B1700
Posts: 14,935
|
Quote:
Originally Posted by tdf-texas
Does anyone know the hitch ball height difference between the standard and the high lift?
|
2 5/8" (67 mm), according to the Dexter Axle web page for the #10 Torflex Lift Kit (K71-707-02)... which I believe is the kit being used currently by Escape.
|
|
|
04-12-2016, 05:43 PM
|
#11
|
Senior Member
Join Date: Mar 2014
Location: petaluma, California
Trailer: 2015 Escape 21 2002 Tundra 4x4 V-8 tow package.
Posts: 163
|
Quote:
Originally Posted by Brian B-P
|
Yes, I had the high lift option installed at the factory on my 21 and it does measure 2 5/8" ETI say's the standard height is 19"
|
|
|
|
Thread Tools |
|
Display Modes |
Linear Mode
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
» Recent Discussions |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|