Trailer: New 21 Escape (not classic)10/16 Sold Lil Snoozy 7/16
Posts: 484
fan blade
Yes How do you release fan blade is it that little allen skrew and then slide down shaft ? Thats what it looks like I don't like to break plastic parts .jim w.
I installed one from scratch and I agree with the others - the swap out is VERY simple, and no sealant required. Just remove inside trim, disconnect wires, then 4 screws up on top (2 on each side) and the assembly lifts right off the flange! Sit new one in, and reverse process! Good luck!
__________________
Joe and Cherie
Currently: 2013 Eggcamper
Someday: Escape 5.0TA
Location: Retired from Dallas & Full-Timing, Texas
Trailer: 2017 21' Escape as of 01/16/17
Posts: 1,312
Maxxair Fan replacement
Quote:
Originally Posted by jwscarab
Fred,
I installed one from scratch and I agree with the others - the swap out is VERY simple, and no sealant required. Just remove inside trim, disconnect wires, then 4 screws up on top (2 on each side) and the assembly lifts right off the flange! Sit new one in, and reverse process! Good luck!
Thanks for that! I will try it in a couple of days!
Fred M.
__________________
Fred M.
"Whoever said retirement was overrated...
...never had an Escape"