I was wondering, could any of you post a picture of the u-shaped cushion configuration, both with table up and in bed config? I am going to attempt a mod for ours, converting from a non-U dinette. I think I have an idea what the cushion config is but I want to double check. Thanks in advance!
This looks great. For the side back cushions, how did you get the slant to the back? I found a site called cushionsource.com. Where did you go to get the cushions?
We opted to make a smaller table top to ease getting in and out and fabricated two separate bed supports allowing a single bed configuration or a full size equivalent to the Escape version. By making these thicker and bracing the support we eliminated the sag of the factory table used to make the bed up as per the set up as delivered from the factory.
This looks great. For the side back cushions, how did you get the slant to the back? I found a site called cushionsource.com. Where did you go to get the cushions?
The same as many others...large pool noodles. Also allows a little ventilation and keeps some of the seat back off the wall.
__________________
So many modifications...so little time.