Multiplex Settings

[Gary Rhodesv]

Regarding MultiPlex Toggle Settings, in as few words possible, can someone share w/me correct position of toggle switch when plugged into Shore Power, and where to put toggle switch when 12v power is coming from Solar/Battery…thank you

 

[GinoandLinda]

I am not understanding which switch you are speaking of. Most Escapes come with a toggle that basically turns on the camper or turns off the camper. The stock toggle should be up whenever you use the trailer, regardless of solar or shore power. Could you tell us more about your trailer, perhaps post a picture of the toggle in question?

 

[Gary Rhodesv]

I am not understanding which switch you are speaking of. Most Escapes come with a toggle that basically turns on the camper or turns off the camper. The stock toggle should be up whenever you use the trailer, regardless of solar or shore power. Could you tell us more about your trailer, perhaps post a picture of the toggle in question?

Thank you, all best

 

[Luvnlife-ESC]

This switch

 

[LRL]

Shore power: Charger only (far left); 12V battery power only: “off” (middle position); battery power and wanting to run inverter for alternating current: “on,” (far right). When you flip far right, you’ll also see a green light next to “inverter on.”

 

[GinoandLinda]

This YouTube should explain it

 

[LRL]

Well. All I can say is in “off” my 12V works just fine. In “charger only” my shore power works AND charges batteries. When not connected to shore power and wanting to use an AC device, “on” does the trick. This has worked for me on all my trips in the past year, and it’s what ETI explained to me when I asked. 12V works in the “charge only” position, but you’ll note that shore power does as well. You’ll see the amp number light up to whatever you set. In “off” 12V works, but you’re getting no potential input from shore power. To confirm this, I just now tested the above and it is indeed just as I say… at least in my 1 year old E23.