Replaced tabletop and table legs 21 ft

[padlin]

Where the post attaches to the floor - We have the original table with 2 legs. What would that look like, to replace that with what you have? How have others covered up the holes left from the 2-legged table, and with what kind of success? Thanks all.

Mine left some holes in the floor exposed, I think they were #12 screws so they are pretty big. I used a vinyl floor repair kit, worked fine. I know where the holes are and can see the fix if I look, no one else would ever notice. Similar to this one,

https://www.homedepot.com/p/CalFlor...AhMVEALw_wcB&dclid=CNjRxdLO6dsCFcpANwodl3AAPg

 

[titanizer]

Yes, the holes are very visible. I used a light colored epoxy wood filler to fill them. I have the factory flooring which is light colored. They are almost invisible now; you would not notice them unless you knew. I don't have a picture, but will get one the next time I'm at my camper.

 

[davidmurphy02]

How thick is the plywood floor? And is there any space underneath it or does it sit directly on the shell? Just wondering about screw length.

 

[bjp447]

What pedestal did you use? Been thinking about it but have not seen it done.
I assume the table is permanently mounted and can't be easily removed. I am
thinking about getting to the electronics below the table. It could be a pain
getting to them with the table there

Bruce and carmella
2014 Escape 21

 

[padlin]

Don't remember the screw length, I just added an 1/4" to the existing screws to make up for the thicker base of the Springfield.