Originally Posted by currinh
I think you're right, there is a problem. I must have tried the fit before final assembly. I'll have to cut out the support rails to clear the wings of the "platform". I think that will fix it but the table might tilt for lack of support in the front. I may have to trim the "platform" back at the front and put a lip on the shelf to support the front of the table. It is fixable.
Thanks for the observation. I'd likely have found this in the middle of nowhere trying to set up the bed. Much easier to fix at home.
Hi: currinh... A little light sanding ought a do the trick!!! Alf
escape artist N.S. of Lake Erie
Quote Bugs Bunny..."Don't take life too seriously, none of us get out of it ALIVE"!!!
'10 Frontier CC. S.E. 4X4 Lng. Bed V6 '14 Escape 5.0TA
St.Thomas Ont.( Not the Virgin Islands)