|
Anderson Leveling system for 21'
Hi all, I've been asked to share some pictures of Anderson leveling wedges that I cut so they would work with the axle locations on the new 21. The files are as follows:
#4497 View of the cut levelers
#4502 Distance between center leveler and the tire after the cut
#4503 Ready to start leveling
#4505 On top with chalks installed
#4507 Completely down, levelers ready to be removed
#4509 Front tire is off the ground and ready for flat repair
#4511 Tip to center of hold = 2 5/16", Tip to end of cut = 1 1/2"
#4513 Angle of cut picture
I cut them with a table saw, only because that's the best way I had to control and match the cuts. These things are a little difficult to hold due to their shape and material ( they're slippery). I cut both levelers because I wanted both tires to rise at the same rate from the same starting point.
|
Threaded Mode
