Raised floor measurement

[Beekeeper]

Our trailer is 50 miles away. I want to buy a rug for the raised floor under the table. We have a 21C with U shaped dinette and Lagun mount table. Does anyone have the measurement of that bit of raised floor? Thanks

[7Gentex]

Not exactly what you asked, but may help:


Per the ETI 21C configuration guide, the space between the dinette benches is 32" wide, and per a response from ETI on the 21C U-Shaped dinette table, the table is 29" long.

[Ron in BC]

Measured mine. 34" x 42 1/2"

Ron

[7Gentex]

Originally Posted by Ron in BC

Measured mine. 34" x 42 1/2"

Ron

With a U Dinette?

[Beekeeper]

Ron. Oops. It was u shaped dinette. Thanks for catching it and for the measurements.

[Ron in BC]

My oops, didn't notice the "U".

So the "U" is 2" less width?

Ron

[7Gentex]

Originally Posted by Ron in BC

My oops, didn't notice the "U".

So the "U" is 2" less width?

Ron

The 32" wide value came from the 21C Configuration PDF from ETI.


per the PDF - "Dimensions are approximate and not drawn to scale"


Believe both "straight" and "U" are the same......nominally!


Do the dinette faces below the cushions slope "outboard"?

[Beekeeper]

Originally Posted by 7Gentex

The 32" wide value came from the 21C Configuration PDF from ETI.


per the PDF - "Dimensions are approximate and not drawn to scale"


Believe both "straight" and "U" are the same......nominally!


Do the dinette faces below the cushions slope "outboard"?

There is a wooden rail on either short side of the dinette to hold the table if you want to use it as a bed. I have not noticed a slope. We can always wait and measure the space in a week or so when we are back in the Escape. I was just looking to have something warm for my feet, while sitting at the table, since I am not an inside shoe person and it is getting cold.

[gbaglo]

You might get a pair of slippers for Christmas.

[Ron in BC]

Well my non-nominal and non-approximate measurement for the 21C regular dinette is:

Width from mini baseboard trim; rear, 34 1/8", front, 33 15/16"

I can't see why the "U" shaped dinette would have less width. That would seem to make a smaller footwell for a design meant to have more feet in it.

Ron

[Bea]

Originally Posted by Beekeeper

Our trailer is 50 miles away. I want to buy a rug for the raised floor under the table. We have a 21C with U shaped dinette and Lagun mount table. Does anyone have the measurement of that bit of raised floor? Thanks

The raised floor measurements of our 21C with a U shaped dinette is 30.5 in x 34.5 in. Hope you find a nice rug!! -Bea

[Vermilye]

Originally Posted by Bea

The raised floor measurements of our 21C with a U shaped dinette is 30.5 in x 34.5 in. Hope you find a nice rug!! -Bea

Same for mine (2017 21C) You will need to notch the rug for the moulding corner piece at the refrigerator, and use a carpet thin enough to slide under the converter.

[Beekeeper]

Many thanks to all of you. I really appreciate the information. We will be placing an order.