Rain diverter above awning windows

[advenas]

In reply to the OP question here you go...

https://www.amazon.com/RV-Weather-St...s%2C222&sr=8-8

In reading the thread I remembered I need to put on the window gutters also. So I asked Escape today and they sent me the link above to the material.

[diannelgraham]

Originally Posted by advenas

In reply to the OP question here you go...

https://www.amazon.com/RV-Weather-St...s%2C222&sr=8-8

In reading the thread I remembered I need to put on the window gutters also. So I asked Escape today and they sent me the link above to the material.

Oh my gosh finally! Just ask Escape for a link they have always sent me one for parts...but then we might no longer have the guessing maybe posts

[Upfisk]

Yes, that's the link they sent me. I'll use it on my project

[7Gentex]

Originally Posted by advenas

In reply to the OP question here you go...

https://www.amazon.com/RV-Weather-St...s%2C222&sr=8-8

In reading the thread I remembered I need to put on the window gutters also. So I asked Escape today and they sent me the link above to the material.

Ah................Nope. 2 7/8" ?


My be if you trim it down to about 1".

[advenas]

Question for the OP, does this seem to be the same product that came on your trailer?

I just reread the Escape response and it says "similar" product to what they use at the factory for the window gutter. So it appears to me either you adjust or keep looking. Not sure why they can't supply the specific product unless it's a special order item for the Escape factory and not the general public. Regardless at least I've got an idea to run with.

[Starbrightsteve]

Vintage trailer supply sells a drip cap for above windows. They have them from 11” up to 33.5” long. They extend 1 1/4” or so from the surface they are mounted on.

[7Gentex]

Originally Posted by advenas

Question for the OP, does this seem to be the same product that came on your trailer?

I just reread the Escape response and it says "similar" product to what they use at the factory for the window gutter. So it appears to me either you adjust or keep looking. Not sure why they can't supply the specific product unless it's a special order item for the Escape factory and not the general public. Regardless at least I've got an idea to run with.

See post #19 on page #1 of this thread - ETI has it specially made.

[advenas]

Originally Posted by 7Gentex

See post #19 on page #1 of this thread - ETI has it specially made.

You're right. I had missed that.

[7Gentex]

Originally Posted by advenas

You're right. I had missed that.

All the ones I have found on Amazon and similar have the adhesive on the "long side", were ETI has it on the "short" side.

[7Gentex]

Was looking at how ETI installs the rain guttier only to the start of the radius of the window corners. Seems like that may leave an area open for dribbles, or is the hinge area the potential culprit? I was planning on doing like ETI does on my new frameless kitchen window......